Automatic Number Plate Recognition solution (ANPR)
Tattile ANPR & 2N intercoms
On this page we will go through connecting 2N IP Intercom with the Automatic Number Plate Recognition solution (ANPR) of Tattile and will define in this way an access control system based on the recognition of a car-plate and a RFID card.
Tattile HW & SW
Product | FW |
---|---|
Tattile ANPR System, model Vega Basic F01750 | All versions |
2N IP Intercom HW & SW
Model | Description | FW |
---|---|---|
9151102CHRW | 2N® IP Force – 2 buttons & HD camera (card reader ready) & 10W speaker | 2.23.0.32.6 |
9151017 | 2N® IP Force – 13.56MHz smart card reader NFC ready (suitable for IP Force only) it includes Wiegand interface, 2 logical inputs, 1 relay, 1 active output and Tamper switch | |
9134174 | Mifare RFID key fob 13.56MHz |
Connection
Connect the Wiegand module of 2N® IP Force (see connector below) to the connector of the Vega Basic camera:
2N® IP Force Wiegand module | Tattile Vega Basic | Signal |
---|---|---|
GND | 15 | GND |
W0 | 8 | W0 |
W1 | 10 | W1 |
2N® IP Force connection
Vega Basic connection
Configuration
2N® IP Force
Wiegand module and Door/Switch
Set up the Interface Mode= Input and Receive Code Format = Wiegand 26-bit. Configure the Associated Switch and the Switch (in figure Door Lock Switch and Switch 1).
Configure a User that will include n.2 Card id: the first one is RFID card number, the second one is the code received from the Wiegand connection, when the camera of Tattile decodes a valid Plate, associated to this User.
Tattile Vega Basic
Set the camera according to next pictures.
Plate reader – Events Actions webpage
Webpage dedicated to the single Event Action
System – Serial Ports webpage