3.3 Intercom Control as Viewed by Internal User

Call Answering

You can answer the incoming calls to the 2N IP Solo  intercom using your phone like any other calls. You can unlock the door, activate/deactivate a user/profile via your phone keypad during the call. The calls, however, are time-limited to avoid unintentional blocking of the 2N IP Solo line. Set the maximum call duration in the Call time limit (refer to the Intercom Configuration / Services / Phone / Calls subsection of Configuration Manual). Press # on your phone anytime to extend the call time. The automatic call termination is signalled with a short beep 10 s before the call end.

Calling to 2N IP Solo

2N IP Solo allows you to answer incoming calls. Set the required parameters in the Incoming calls group; refer to the Intercom Configuration / Services / Phone / Calls subsection of Configuration Manual.

Door Opening (Switch Activation) by Code

2N IP Solo is equipped with a door unlocking switch. Enter the valid code (refer to the Intercom Configuration / Hardware / Switches subsection of Configuration Manual) using your phone keypad to activate this switch.

Procedure: 

  • Enter the switch 1 or 2 activating code using your phone keypad and press  for confirmation. Confirmation is unnecessary if the Lock code without confirmation is enabled, refer to the  Intercom Configuration / Hardware / Switches / Advanced subsection of Configuration Manual.
  • A valid code is signalled by the  sound. An invalid code or interruption longer than as defined in Timeout for Entering Numbers is signalled by the  sound.