4.8 ALARM Button Test

This function informs that the ALARM button got stuck in the lift cabin.

Set the timeout in seconds after which the button shall be considered jammed in parameter 969 (ALARM button test). Then, the event defined via the 2N Service Tool Events menu (Jammed button) will be executed.

The following options are available:

  • IO module output activation
  • IO module output deactivation
  • Send SMS – set the phone number and text (for GSM/UMTS module only)
  • Send system SMS – set the phone number (for GSM/UMTS module only)
  • Operational call – this call is set up to the number defined in parameters 081–088 (Operational call) and uses CPC Antenna, CPC KONE or P100 for transmissions
    Operational calls are possible with this event only if CPC Antenna 2N ext., CPC KONE 2N ext or P100 2N Ext are set in parameters 181-186. Make sure that CPC KONE or P100 is set in the Control Panel for the CPC KONE 2N Ext and P100 2N Ext protocols. Make sure that CPC Antenna 2N Ext is set in the Control Panel for the CPC Antenna 2N Ext protocol.

Caution

  • Multiple events can be set up (output activation + operational call, e.g.).
  • SMS can be sent only if the LTE module is installed.
  • If you set the operational call option and CPC/P100 2N ext confirmation, the audio unit type (cabin 1 or 2) and shaft number is displayed for the stuck button (if the call is received via the 2N Lift8 server).
  • Set the IO module activation/deactivation timeout to 1 s at least. If you set 0, the function will not work.

The next event can be generated even after the button has been fixed. The events related to a stuck button (IO module output activation/deactivation, send SMS or operational call) can be executed. Set the parameters via the Service Tool again (Configuration – Events – Stuck button).

 

Caution

  • We recommend you to set a rather long interval in parameter 969 to avoid unintentional event generation.
  • Recommended value: 300 s.

Parameter 990

You can set the operational call (audio error, audio repaired) via parameter 990. For more details, refer to the Programming chapter.

Caution

  • If you set the operational call via parameter 990 and Events menu (script), the call will be set up twice.