4.2 Control Centre Instructions
DTMF Control during Call
Tone dialling can be used for 2N® LiftIP control during calls as shown in the table below if Automatic dialling with confirmation is enabled. Commands 1 to 5 are arranged conveniently for typical use.
DTMF character | Function description |
| Confirm to 2N® LiftIP that the call was successful. 2N® LiftIP mutes the currently played announcement and sends its confirmation signal; the call goes on until the call time limit is exhausted and any of the following commands can be used. |
| Play information on the communicator (parameter 979). |
| Extend the call – extend the call by 120 s (parameter 912). Can be used repeatedly. |
| Terminate the call. |
The above table applies to Loud automatic dialling with confirmation.
List of 2N® LiftIP Announcements
Announcement | Meaning |
|---|---|
“Please wait for connection” | The announcement is played to the lift user when the call is being set up (before confirmation). |
| “This is an emergency call, to confirm connection press 1” | The announcement is played to the control centre before call confirmation. |
“Connection confirmed” | The announcement is played after call confirmation. |
| “This is communicator with ....” | The announcement is played only if the control centre presses DTMF 3 after call confirmation. The communicator sends information on its product number or Id if available (parameter 974). |
“Attention, the call will end the soon, to extended the call press 4" | The announcement signals during an outgoing/incoming call that the maximum call duration shall expire in 10 seconds. |
“End of call” | The announcement is sent before hang-up. |
| “This is a checking call, to confirm connection press 1” | The announcement is sent to the control centre only (if DTMF 1 confirmation is enabled). |
| The rescue process has been completed. | Emergency signalling end confirmation |
2N® LiftIP Identification
When the alarm call is confirmed, the control centre can press DTMF 3 to get the communicator serial number. The communicator Id is played if parameter 974 is completed. Relevant information can be obtained during an incoming call too (Press 9 for administration – Press 3 for information on this communicator).