6.10 Ring Tones

To set the ringing tones use the Global data – Ring patterns menu. Each ringing tone consists of a ring pattern and Cornet tune. Some terminals are unable to change the ring tune and use the ring pattern only. See a list of available ring patterns on the left. You can add, remove or rename the ring patterns using the context menu. During database creation, default progress tone patterns are created that can be edited or removed as necessary. To restore the default settings without removing the tones created by you, use the Update option. To restore the default settings and remove all the ring tones, use the Default option in the context menu. To create the ring tones, use the following parameters:

Figure: View of Ring Tone Configuration Menu

• Repeat – make a tone pattern being played repeatedly. If this option is not checked, the tone pattern is used only once.
• Cornet tune – assign a ring tone tune to a selected ring pattern in the StarPoint key telephones.
• BRI signal – set the ring tone signalling for the ISDN terminals that support multi-tune ringing.
• Delay – set the ring pattern using two columns and four rows. Set the ON and OFF columns for each row to be used. ON represents the ring current time and OFF represents the row resumption delay. Both the parameters are set in milliseconds.