5.6.4 LIFT1
The LIFT1 folder helps you enable and set programming of the connected 2N® Lift1 lift communicator using SMS. Having received an SMS with the programming request, 2N® EasyGate IP establishes connection with 2N® Lift1 via a phone line and programs it using the CPC protocol.
- Enable Service – enable/disable 2N® Lift1 SMS programming.
- Pre-Authorization – set the EGIP or Lift1 password authorization before SMS request processing. The EGIP password matches the 2N® EasyGate IP password (serial number / security code). The default LIFT1 password for pre-authorization is 12345.
- LIFT1 Password – use the password to change the LIFT1 pre-authorization password. The password can contain up to 19 digits. The password change will also be automatically written into Lift1 password in Services / Battery status and vice versa.
Caution
- We recommend that you use EGIP or LIFT1 password authorization, which is performed by 2N® EasyGate IP itself. If no pre-authorization is required, authorization will be performed by 2N® Lift1 by line dial-in and short-time line occupation.
SMS Command | SMS Format | Note |
---|---|---|
Configuration (CNF) | L1 CNF PASSWORD | The example below programs 2N® Lift1 ALARM button memory 1 and 2 for the specified phone numbers. SMS format: L1 CNF 12345 011=00420222222222 012=00420111111111
|
Factory default reset (DEF) | L1 DEF PASSWORD | |
Profile n selection (SET) | L1 SET PASSWORD N |
|
Feedbacks for Commands | |
---|---|
L1 CNF OK | Setting ok |
L1 DEF OK | |
L1 SET OK | |
L1 ERR Invalid Message | Prefix L1 invalid |
L1 ERR Unknown Command | Wrong command other than CNF, DEF, SET and RST |
L1 ERR Invalid Password | Invalid password |
L1 ERR Invalid Parameters | Invalid CNF and SET parameters |
L1 ERR Invalid Syntax | Invalid characters (spaces, equal signs, etc.) |
L1 ERR Does not Respond |
|
Caution
- Multiple commands cannot be combined in a single SMS.
- The maximum SMS length is 140–160 characters; if a setting outside the value range is requested or an error occurs in the SMS, the setting change will not be performed.