Configuration SMS messages

Below you can find list of possible SMS configuration commands for 2N® Lift1, such configuration is possible only in combination with 2N® EasyGate PRO with FW version xxxx. In list below, you can see exact format of available messages. You can use up to 160 characters per SMS message. 

1. Configuration:
   L1 CNF 12345 011=00420222222222 012=00420111111111 (You can use any available parameter from parameter chart)
2. Put 2N® Lift1 into the factory default:
   L1 DEF 12345
3. Choose profile(if you set profile 1, than it is equal to the point 2 - DEF):
   L1 SET 12345 2
4. Restart:
   L1 RST 12345

Possible responses

Confirmation messages

L1 CNF OK - configuration was applied

L1 DEF OK - reset to factory default was successful

L1 SET OK - switch of profile was successful

L1 RST OK - restart of the device was successful

Error messages

L1 ERR Invalid Message  -If L1 sign is missing or is different (L2, L4 WHATEVER ELSE)

L1 ERR Unknown Command  -If another command then CNF, DEF, SET a RST was applied (DFE FNC ETC ...)

L1 ERR Invalid Password  - Incorrect password for programming (default is 12345)

L1 ERR Invalid Parameters  - releated to CNF and SET.

L1 ERR Invalid Syntax  -Syntax error, when there are some spaces or chars where shouldn’t be

L1 ERR Does not Respond  - doesn’t answer the call after 60 sec
                                               - when the call is answered but doesn’t react for CPC programming
                                               - hang up during programming
                                               - doesnt react on WRITE_START, WRITE_CONFIRM, or CRC_REQUEST