2N® Indoor Talk – HTTP Commands – How to configure it

From firmware version 2.34 the 2N^® Indoor Talk answering unit can send HTTP commands by long-pressing the unlock button on the device. Here’s an example of how to set a command for triggering Switch 1 of 2N^® IP Verso.

The HTTP command for triggering Switch 1 on the 2N^® IP Verso is https://IP_address/api/switch/ctrl?switch=1&action=on. You can find the HTTP commands in the HTTP API manual or by accessing the HTTP API TESTool which is part of every 2N IP Intercom and can help you create valid HTTP commands for the desired request type. You can access the TESTool by entering the intercom’s IP address and writing /apitest.html at the end (for example https://192.168.49.88/apitest.html).

After you get the correct HTTP command go to the “Services -> HTTP Command” section of the 2N^® Indoor Talk’s web interface and fill in the required credentials.

URL - the HTTP command

Name - Fill in the name of the HTTP command

Username - required username in case of the HTTP API account for authorisation is set in the command receiving device

Password - required password in case of the HTTP API account for authorisation is set in the command receiving device

After that simply save the settings, and you will be able to send the HTTP command by long-pressing the unlock button on the 2N^® Indoor Talk answering unit.

Used devices:

2N^® IP Verso - FW 2.33.1.42.10

2N^® Indoor Talk - FW 2.34.0.43.3