Install the device holder onto a vertical wall. The recommended installation height is 120 cm above the floor. The product package includes screws and plugs for mounting into classic bricks. Use appropriate installation fittings for a different type of wall material!
Feed the device via an Ethernet PoE adapter (or PoE supporting Ethernet switch/router) or a 12 V / 2 A DC power adapter.
With PoE supply, just snap RJ-45 into the appropriate connector.
With 12 V DC 2 A supply, screw the power adapter plus and minus cables into the appropriate terminal board on the device.
Simultaneous PoE + 12 V / 2 A DC supply is not recommended!
Put the device on the holder as follows:
Place the device carefully from top to bottom with its bottom part slightly away (up to 5 cm) from the wall.
When the device fits to the main holder supports, push the device bottom part onto the wall.
Tighten the safety screws on both the device sides.
