3. 2N® LiftIP 2.0 LAN Location via 2N® Network Scanner
Configure 2N® LiftIP 2.0 via the administration web server. Connect 2N® LiftIP 2.0 to the LAN using a UTP cable and make sure that the device is being fed.
2N®Network Scanner Description
The application is used for retrieving the IP addresses of all the 2N IP devices in the LAN. The application is freely downloadable from the 2N web (www.2n.com). Make sure that Microsoft .NET Framework 2.0 is installed for successful app installation.
- Run the2N® Network Scanner installer.
The Installation Wizard will help you with the installation.
2N®Network Scanner Installation Wizard
- Having installed 2N® Network Scanner, start the application using the Microsoft Windows Start menu.
Upon launch, the application starts search the LAN for all the 2N devices and their smart extensions whose IP addresses are assigned by DHCP or statically set. These devices are then shown in a table.
2N® Network Scanner Window
Choose the 2N® LiftIP 2.0 device to be configured from the list and click it with the right-hand mouse button. Select Browse... to open the 2N® LiftIP 2.0 web administration interface login window for configuration. To change the device IP address, select Config and enter the required static IP address or activate DHCP. Enter a password to confirm the setting change. If the default password has been changed (upon the web interface login), use the current password. If not, the default password is 2n. If the found device is grey highlighted, its IP address cannot be configured using this application. In that case, click Refresh to find the device again and check whether multicast is enabled in your network.
Change of Device IP Address in 2N® Network Scanner