Reset Button

Located among the main unit connectors, the Reset button helps you reset the factory default values, restart the device, find the device IP address and switch the static/dynamic mode.

 

IP Address Finding

Follow the instructions below to identify the current IP address:

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Release the RESET button.
  • The device announces the current IP address via the speaker automatically.

Note

  • The delay after pressing RESET till the first light and sound signalling is set to 15–35 s depending on the 2N IP intercom/answering unit model used.
  • The time interval 18 s applies to the 2N® Indoor View.

Static IP Address Setting

Follow the instructions below to switch on the Static IP address mode (DHCP OFF):

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Release the RESET button.

The following network parameters will be set after restart:

  • IP address: 192.168.1.100
  • Network mask: 255.255.255.0
  • Default gateway: 192.168.1.1

 

Dynamic IP Address Setting

Follow the instructions below to switch on the Static IP address mode (DCHP ON):

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard (approx. for another 3 s).
  • Release the RESET button.

 

Factory Reset

Follow the instructions below to reset the factory default values:

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Wait until the green LED goes off and the red LED goes on again and acoustic signal can be heard (approx. for another 3 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s). 
  • Release the RESET button.

Device Restart

Press the button shortly (< 1 s) to restart the system without changing configuration.

Note

  • For the 2N® Indoor View, the time interval between a quick press of the RESET button and reconnection of the device to the network is 20 s.
  • Žádné štítky