2N® Indoor View allows you to sends syslog messages including relevant device state and process information to a syslog server for recording and further analysis or auditing of the device observed. It is unnecessary to configure this service for common operations.
List of Parameters
- Send Syslog Messages – enable sending of syslog messages to the Syslog server. Make sure that the server address is valid.
- Server Address – set the IP/MAC address of the server on which the Syslog application is running.
- Severity Level – set the severity level of the messages to be sent (Error, Warning, Notice, Info, Debug 1–3). Debug 1–3 level setting is only recommended to facilitate troubleshooting for the Technical Support department.
General overview of local syslog messages.
