2N^® Clip  is equipped with a speaker. Set the phone call and state signaling volume control in this configuration section.
Master Volume (button-controlled) controls the master volume of the device and affects the volume of both the calls and signaling tones. Consider the noise level of the ambient environment while setting this parameter.

Phone Call Volume

Call Volume – set the phone call volume.
Ringing Volume – set the incoming call signal loudness.
Call Progress Tone Volume – set the dial, ring and busy tone volume values. In case the call progress tones are automatically generated by the PBX, this setting will not be applied.

Signaling Volume

Key Beep Volume – set the key beep volume. The volume values are relative against the set master volume.
Warning Tone Volume – set the warning and signaling tone volume values. The volume values are relative against the set master volume.
Do Not Play Warning Tones – disable playing of the following operational state signaling: Internal application started, IP address received and IP address lost.