2N® Indoor Talk is equipped with a speaker. This configuration section helps you set the phone call volume and state signalling volume.
Master volume controls the general device volume including call volume, signalling tone volume, and so on. Consider the noise level of the ambient environment while setting this parameter.
Parameter List
- Call Volume – set the phone call volume.
- Ringtone Volume – set the incoming call ringing volume.
- Call-Progress Tone Volume – set the dial, ring and busy tone volume. In case the call-progress tones are automatically generated by the PBX, this setting will not be applied.
- Key Beep Volume – set the key beep volume. The volume values are relative against the set master volume.
- Warning Tone Volume – set the volume of warning and signalling tones described in the Signalling of Operational Statuses section. The volume values are relative against the set master volume.
- Suppress Warning Tones – suppress signalling of the following operational states. Internal application started, IP address received and IP address lost.
- User sound volume – set the volume of user sounds. The volume values are relative against the set master volume.
- Time Limited DND Mode – Disable ringing for a limited time (silent mode). If this function is activated, the device shall not ring for a limited time when a call comes in.
- DND mode for the doorbell button – if this function is activated, the device shall not ring when the doorbell button is pressed.
- Reject Call – if this function is activated, the device reject calls in the Do not Disturb mode. The function can be used for immediate call redirection at absence to a mobile phone call, for example.
