3.1 Factory Reset

Reset Button

Located among the main unit connectors, the Reset button helps you reset the factory default values, restart the device, find the device IP address and switch the static/dynamic mode.


IP Address Finding

Follow the instructions below to identify the current IP address:

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Release the RESET button.
  • The device announces the current IP address via the speaker automatically.



Note

  • The delay after pressing RESET till the first light and sound signalling is set to 15–35 s depending on the 2N IP intercom/answering unit model used.
  • The time interval 18 s applies to the 2N® Indoor View.

Static IP Address Setting

Follow the instructions below to switch on the Static IP address mode (DHCP OFF):

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Release the RESET button.

The following network parameters will be set after restart:

  • IP address: 192.168.1.100
  • Network mask: 255.255.255.0
  • Default gateway: 192.168.1.1



Dynamic IP Address Setting

Follow the instructions below to switch on the Static IP address mode (DCHP ON):

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard (approx. for another 3 s).
  • Release the RESET button.



Factory Reset

Follow the instructions below to reset the factory default values:

  • Press and hold the RESET button.
  • Wait until the red and green LEDs go on simultaneously and the acoustic signal can be heard (approx. 15–35 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
  • Wait until the green LED goes off and the red LED goes on again and acoustic signal can be heard (approx. for another 3 s).
  • Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s). 
  • Release the RESET button.



Device Restart

Press the button shortly (< 1 s) to restart the system without changing configuration.


Note

  • For the 2N® Indoor View, the time interval between a quick press of the RESET button and reconnection of the device to the network is 20 s.