5.7.1 Example of Settings

The figure above shows an example of an Anti-passback area. All you have to do to set the Anti-passback function is configure the edge devices. The inside devices are not used for entry/exit control.

  • D1 – device D1 is only used for entry to the Anti-passback area.
    • Access point 1 is set for entry.
  • D2 – device D2 is used for both entry and exit.
    • Access point 2 is set for entry, Access point 1 is set for exit.
  • D3 – device D3 is used for both entry and exit.
    • Access point 1 is set for entry, Access point 2 is set for exit.

Caution

  • The Access points in 2N® Access Commander are marked 1 and 2 as follows:
    • Access point 1 = Entry rules
    • Access point 2 = Exit rules
  • Make sure that a reader is added to the device for each Access point.

The table above sums up the device settings in the figure above. Any Access point can be used for entry/exit.