2.2.3 Installation on Mounting Backplate
The Mounting Backplate allows you to install cables below 2N® Access Unit M for surface mounting.
Note
- Shortening of the LAN cable in Part Nos. 9161121, 9161141, 9161151, 9161161 shall not result in a loss of warranty.
Varování
Do not handle the screws on the device back side!
Prepare dowel holes on a selected place and in a selected height using a drilling template shown on the package. Cut a cable installation hole in the backplate.
Pull the metal holder downwards on the device back side to remove it.
Put the cables in the backplate and put the backplate against the wall. If you connect the device to installed cables, connect the wires.
Varování
- Insulate the wire joints with a shrink tube and glue to keep the cover rating as much as possible.
Anchor the backplate to the base using screws and dowels. Screw the metal holder to the backplate
Put the device against the backplate and insert the remaining cables carefully in the backplate.
Insert the device on the holder by pulling it from top to bottom making sure that the holder stops drive under the screw heads on the device back side. When the device fits the holder carrying elements, fix the device position by tightening the screw to the device through the holder hole from the bottom.